Jamba "Sticky" Follow in IS

[Noids]

I have Isboxer pass a command to set my "active" character as Jamba master on window swap. Once I do the swap, I will manually hit shift-alt-f to change follow strobing to the new master again. If you like Isboxer can send a command for you to do this automoatically also, but I prefer the manual setup. I am not sure if you have tried doing it this way, but I don't have any problems getting strobing follow to work with jamba and isboxer, so there are ways to do it, its just a matter of working out a way that suits you best.

[Tizer]

I have Isboxer pass a command to set my "active" character as Jamba master on window swap. Once I do the swap, I will manually hit shift-alt-f to change follow strobing to the new master again. If you like Isboxer can send a command for you to do this automoatically also, but I prefer the manual setup. I am not sure if you have tried doing it this way, but I don't have any problems getting strobing follow to work with jamba and isboxer, so there are ways to do it, its just a matter of working out a way that suits you best.

Humm not doing a shift+alt+f keypress after swapping characters could be where i was coming unstuck....its not a very friendly combination, i might change it to the pgup key and get water shield to activate at the same time as a reminder, also set the camera angle again. hopefully that can all be done in one keypress. :x

[Noids]

no its not. Must admit my follow key is "-" rather than that, but if you are using isboxer defaults then that is what it is from memory. I then just hit a formation key to break follow and switch strobing off.