Quote Originally Posted by Redbeard View Post
I would use the options interface and uncheck the "Enable auto quest completion" box which would grey out the entire screen. Then I would push the settings to the slave.

Which would change nothing.

If the command line works and the button doesnt then perhaps theres an issue with the options interface (or just mine).
Had a look at the code. The problems you describe come from the selection of the quests rather than the completion part. The completion happens after the selections, i.e. after a quest has been selected. So, the command line I mention earlier will sort you out I think. Stick the toggle version of it in macro and you should be able to stop the auto selection, allowing you to choose which quest to pick and then the completion code can run (so leave the enable completion bit on essentially).

Hope that helps!