Jamba 0.5 available for testing (Update 12).

[Fizzler]

I've added a comment on the ticket, but copying the comment here:

I think the problem is the master and slave getting out of sync when you run the

/jamba-follow strobeonme all

in close proximity to

/jamba-team iammaster all
/jamba-follow strobeoff all

A solution would be to have the commands individually on each toon and not just on the master (i.e. drop the all tag and run the command on each toon).

/jamba-follow strobeon mastertoon

/jamba-team master mastertoon
/jamba-follow strobeoff

You need to have more macros and {5 keybinds with key broadcasting / 5 methods} to switch masters this way, but the upsides are no delays while the commands are being sent and hopefully no more strobing on random slave problems.

I have been using Jamba-Macro with variables to make the macro writing simpler - write once, use with many teams.

I'm sure you will be able to use ISBoxer to substitue toons names into macros.

Do you want to give this method a go?

I am still having this issue not sure what is going on. Heck I even changed ISBoxer to do Nothing when I switch toons and still they get stuck in a follow strobe loop but only when they enter combat.

[Jafula]

I am still having this issue not sure what is going on. Heck I even changed ISBoxer to do Nothing when I switch toons and still they get stuck in a follow strobe loop but only when they enter combat.

Do you have auto follow after combat turned on? And you are using follow strobing? I think those two could clash, so make sure auto follow after combat is turned off.

[Fizzler]

Do you have auto follow after combat turned on? And you are using follow strobing? I think those two could clash, so make sure auto follow after combat is turned off.

I have auto follow after combat disabled. I have disabled every automated /slash command related to follow in Jamba and ISBoxer.

If I select a slave and manually enable follow strobe than switch back to my master and engage in combat about 50% of the time the Master will follow strobe the previous slave. I have to manually turn off Follow Strobe when I enter combat.

Even if I have the Master is always strobe checked it does this. I must have done something to mess up the config but I can not figure out what it was. It worked fine for few days when I first installed the DEV load. I have deleted all the WTF Files and even set up a new ISBoxer team from scratch.

It must be a latency issue. Sometimes when I push settings it will be delayed on my slaves. Last night I pushed a setting and it took 15 seconds or more for it to show up on some slaves.

My work around right now is to disable Follow Strobe in combat.

Thanks for all your hard work on this project.