Ok, well I had it setup where my 1st monitor was full screen, second monitor was 3 screens. I switched to full screen (one on each monitor) while my wife dual boxes the 2 others in split screen on another PC. Now, I cleared the command list and also "reset" the regions. I set it on display1 as enable maximizer 1280x1024, snap to grid. Shows region0 (x,y 0,0). Same setup on display2 (except region1). I set up the commands with the correct regions.......but both acct1 and acct2 shows up in the middle of my screen on monitor1. I have to move my acct2 over to monitor2, dble click to maximize, and repeat with acct1 on monitor1.

I don't know what I did wrong....any clue?