Druids Herb gathering with Mouse Repeat

[Rocknard]

I am having a little trouble on my Druid's when trying to herb, as no doubt any other druid Multiboxer has noticed when flying down, my four slaves never touch the ground fully so they cannot herb. I have read previous forums on this and decided to go with incorporating my X sit/down key I am trying to get it just to tap the "sit/down" keybind not hold it down. However, it's not quite working; I have uploaded my few configurations surrounding the setting up of the X keybind.

currently, I created a new Variable Keystroke for X, this works fine when I use the X keybind in game, but what I wanted was to use the default mouse repeat toggle which is virtually mapped to another key and inside either of these mapped key's create a variable keystroke action.

So I press let's say Num 12 to toggle Mouse repeat, and in this mapped key have an action to send X to all, I would think that is what it is trying to do, but this does not seem to be the case. I have attached images of these specific configurations/keymaps any thoughts?

[Ughmahedhurtz]

What do your characters actually do when you press the X button?

[mbox_bob]

Any Movement Keys will require the HOLD option to be set on the mapped key. This may have an adverse affect on various actions depending on what they are (simply, all modifiers will be munged into one big bucket and apply to all other keys being sent).

So, if X/NUM+/NUM12 (I got a bit confused on what your hotkey actually was) results in a in game movement key, then it will need hold.

If not, then I can be pretty sure if your Move Down variable keystroke is set to send X, then that is exactly what it is doing. How the game responds to that will depend on what else is going on at the time.

There is a debugging console to verify what ISBoxer sends to the game. http://isboxer.com/wiki/ISBoxer_Debugging_Console

[MiRai]

I am trying to get it just to tap the "sit/down" keybind not hold it down.

If you want to move your characters using ISBoxer, then you will need to do it the exact same as you do in game: hold the key down to move them, and release it to stop them in position. From what it looks like in your images, ISBoxer is sending the X key to the game client, but "tapping" the key is going to get you an immediate press and release of the key, and the characters will not move anywhere.

Mapped Keys for movement not only need to be held down, but they also have to have the "Hold" option enabled (located in the Advanced section of the Mapped Key itself), which may cause them to act differently than when the "Hold" option is not enabled (e.g. can't use "pressed or released").

In addition, and in the future, please share your configuration, as images rarely show the entire picture of what needs to be looked at.

[Rocknard]

Thank you all for the reply I figured it needed to be hold down option; I will upload my config next time and thank you all for the replies.