For accepting quests, make sure that your Jamba is set up so that your slave sees the main toon as the master as show near the bottom of this post.

Once that's set up, make sure you have Click to Move enabled on your slave so they can reach the target ans explained about halfway through this post under Quest > Interacting.

To accept and turn in quests, you'll target the NPC with your main, have your slave assist you so they also target the NPC and then hit your Interact with Target button. Your main should open the quest dialogue and your slave should move as close as they need to and open the same quest dialogue.


If it's not Jamba's setup that's causing the problems, then there is probably something not being sent in HotKeyNet. If that's the case, paste a copy of the script you are using along with the messages that HotKeyNet posts when you send your Interact key.