Keyclone, I'm having the same issue, after starting wow windows using the keyclone maximizer the Config.wtf resolution reverts to 800x600 if the keyclone maximizer setting does not match the approved WoW list of resolutions (it does not matter that it's proper ratio, if it's smaller it reverts). However, if I change the Config.wtf file back to 1440x900 then start up a wow, it comes up correctly (started manually). If I then use the old "Maximizer" program (not in Keyclone) the window that pops up stays at 1440x900 and also resizes down to the correct aspect on my second monitor. The Config.wtf file remains untouched at 1440x900. If I exit out of wow then start it up again using keyclone maximizer the settings are reset again to 800x600! Can you provide the command line you are using from within keyclone maximizer? I'd like to test it manually from the command line to see what happens. Also, as a test a few days ago I put Maximizer as the command into keyclone and it started properly but then PiP did not work. Will PiP be available in the future to windows that were not started with keyclone maximizer?