Quote Originally Posted by Mosg2 View Post
Manually got it set to 9/9/9/27 but when I change it to 1600 it won't POST.
leave it at 9 9 9 24, thats a better setting technically, but you'll never see the difference, also check to make sure that the voltage defaulted correctly, with ddr3 there are different voltages, for the most part all of ddr2 was the same (1.65 i think) but i have seen ddr3 go from 1.1 to 1.65 if your board picks up the XMS profile of your memory use that, if not, just let it default to w/e as long as the voltage is correct (lower is ok, higher isn't unless your o/c'ing your ram, and on sandy bridge you don't wanna do that, it can cause some major stability issues)