Hi again.

Not sure if this is a bug or just something you hadn't thought about. I have 5 windows set up one on my right side 19" monitor and 4 on my left side 22" monitor. The aspect ratios are the same on both monitors. region0 is the main one that is on the display2 in the maximizer setup and region1-4 are on the display1. If I always switch back and forth between the main window and a different window things go smoothly. This is a bit hard to explain so I'll try to do it in steps

- Situation normal
3 2
4 1 0


-swap one

3 2
4 0 1

at this point if I swap back to one either by pressing one or zero everything works as it should. If I swap to 2 for instance the situation will look like

32 0
4 1

The maximizer loses proper positioning for region 0 and swaps it over to display1 in the top left corner. Granted it is at the top left corner on display2 too.

The same happens if I press the hotkey for region 0 first and then before pressing region 0 hotkey again press another hotkey.
There doesn't seem to be any way to rectify the situation short of shutting down the clients and restarting with the keyclone command again.