curser bouncing off maximised window

[Mac]

I'm having some strange intermittent behavior, wondering if someone else has seen it or not, if so, do you have a possible a solution?

I start up one of my clients with keyclone, and maximizer puts the window up in the top left corner of the right hand monitor just as I would like. Things are going fine, and for some reason , all of the sudden ( I haven't been able to figure out why yet) when I try to move my cursor from my main screen on the left hand side, over to the client on the right hand side to loot or something, the cursor will bounce off the window back over to the main screen. When it does this, my camera angle on the right hand side repositions itself directly over the head of the toon looking downwards and spins the view about 90 degrees. Each subsequent attempt to get focus on that client window rejects the cursor back over to the main window and spins the camera view on the first toon a little more. The only way to stop it is to close that window and start again.

Also, sometimes I will only have one window up, say in the tip left corner, and for some reason it will jump and reposition itself on the bottom right hand corner?

I hope I was able to explain that correctly, has anyone dealt with this yet?

[Atorifan]

No help for you here, but I was having the same problem on my other pc. I'd try to click an icon in the lower section, the icon would bounce all the way to the bottom of the upper section. Macro icon attached to the mouse pointer. I'd drag the icon back in place, and bam it would happen again. Sometimes it worked fine. But that seemed a recurrent problem for me.

[Lusar]

This happened to me a few times when i was looting or running with my mouse. My problem ended up being it the client still thinking i had a mouse key pressed down . All i do to fix it was click each mouse button as I'm try to move it to the client that is messing up...

[Notes]

If turned on, turn it off:

pass mouse click

focus follows mous

both found in the general tab in Keyclone

Hope it helps.

[Mac]

Thanks for the input folks, however I keep tweaking the settings, and I'm still randomly getting this problem.

The only solution is to log out of the client and start it back up again. Yesterday I had a similar problem happen but in reverse, instead of the cursor bouncing off the window, as it had done earlier in the day, the client wouldn't "let go" of the cursor. When I tried to move to my main window, the curser kept getting held back ?( I'm at a loss to figure this one out. I can't seem to peg it to any certain key strokes or events.

[Tehtsuo]

I have a similar problem, where the mouse relocates at random to a point in the middle edge of a window. I've found that turning off Mouse follows focus stops this though. I've just learned to double click on corpses to loot or quest npcs instead of single click to grab focus and activate the object.

[keyclone]

make sure 'pass mouse clicks' is not on.

'focus follows mouse' should not effect this problem, except for in the case of using PiP to swap windows