My 2 ISBoxer 2 Step Macro and Setup

[Ualaa]

Can you dynamically switch the characters in the ATGs? For example if I switch talents for one Schamie from elemental to resto and push him from the elemntal ATG to the Resto ATG, will he stop doing elemental 'stuff'? Or are the macros prebuild upfront?

You can use a mapped key to add or remove a toon from an Action Target Group.
New Target Group Action
Then set:
- Target
- Action Target Group
- And choose Join or Leave

I've used this in the past with dual-talent characters.
My initial PvE group would sometimes go:
1x Prot Paladin
1x Resto Shaman
3x Elemental Shaman

And at other times go:
1x Prot Paladin
4x Elemental Shaman

When my dual-spec shammy was Elemental, my hotkey would remove the other three from the ATG which received the Repeater Region heal clicks.
And when they were all Elemental, it would add the other three, so all four would do the healing.




Neat idea on the ATG's.
And dynamically changing them even in combat.
So a toon can change roles on the fly.

The big macro exists for all the toons.
And basically says, if you're an Elemental Shaman do this in this order.
IE, a castsequence.

The Resto Shaman will ignore that, since they're not a part of the Elemental Shaman ATG.
But if you were to add them to that group...

Cannot change specs in combat.
But you could easily add a hybrid or two, to the Healing Group, if the main healer went down.
Or similarly, if you need no heals for trash, add the Healer to the DPS group.
If you get a chance outside of combat, you could do a gear/spec swap too.