Jamba + ISBOXER & Click to Move (CTM) & IWT (Interact with Target)

[Acidburning]

Just reactivated 2 of the 5 accounts. Wanted to play around with some friends on a new server. Transferred 2 toons.

Under
Follow/JambaStrobe/JambaMaster
I had a Do CTM Off and Do CTM on
They just switched: /console AutoInteract 1 or 0

So I noticed when I was swapping toons it was not working.

Took out the CTM from isboxer/ jambamaster, and just changed CTM in wow, and my interact with target works.

Anything change in this last big patch?


Thanks,
acid

[Ualaa]

If you do an export, from IS Boxer Toolkit, it updates the addon version (ISBOXER) to be current.
Jamba has an update as well.

My CTM stuff works properly, without adjustment.
Melee toons always have CTM on.
Caster toons always have CTM on for the slaves, and off for the active toon.

My IWT also works, without adjustment.
I can press a hotkey, for everyone to IWT once (quest givers/flight paths/inn keepers).
Also have IWT (melee toons only) built into my melee dps keys.
And a toggle to enable/disable the auto melee IWT.

[Mercbeast]

If you do an export, from IS Boxer Toolkit, it updates the addon version (ISBOXER) to be current.
Jamba has an update as well.

My CTM stuff works properly, without adjustment.
Melee toons always have CTM on.
Caster toons always have CTM on for the slaves, and off for the active toon.

My IWT also works, without adjustment.
I can press a hotkey, for everyone to IWT once (quest givers/flight paths/inn keepers).
Also have IWT (melee toons only) built into my melee dps keys.
And a toggle to enable/disable the auto melee IWT.

I'm having issues with IWT currently. When I am turning in quests, my team always switches targets to the last NPC I interacted with and runs back to him/her and interacts. This also occurs in melee combat (It is a melee team). If I am close to the last mob I killed, I have issues with IWT auto targeting my previous killed target. The only work around I've found at the moment is to toggle broadcasting and hit esc a couple times. This seems to properly clear the targeting and allow me to IWT with the next npc.

I expect you use basically a default IWT setup for the first bit, I followed your guide for that. I've tried tying IWT to my melee macro, as well as having it by itself. Both ways it is doing this last target stuff. Any ideas?

Also, how did you go about setting up the purpose built melee DPS key with IWT? Did you just duplicate the other IWT keybind and then tie that to your melee DPS button is is there more finesse involved?

[Ualaa]

Assist, however you do it, takes a little bit of time... roughly double your latency.
It is a limitation of warcraft.

When I want toons to change target, I have my master change target first.
If I wait a second or so, the slaves will correctly assist.
Whether I press an FTL DPS key (to kill a new target).
Or if I go with my assist key.

When I have my IWT toggle enabled, it works the same.
As in, if I give the game a moment for assist to work correctly, the toons IWT the correct target.
But if I switch, and immediately hit IWT, often that's too quick for assist to correctly read the new target.

For me, it's always been that way.



For the IWT key.
Ensure it assists the master, before sending the IWT Keybind.

If you want it to work every time, without ever going back to a previous target.
The only solution really is to assist first.
Wait a second (at least double your latency, which will probably be half a second or less).
Then hit your IWT.