Slave hunter pet assist...

[valle2000]

The pet will change to other mobs after the mob you send it at dies and the other mobs hit the pet (AOE, cleave, etc). You can put the pet on passive and it can be sent to kill a mob and run back to you when it is done. That is a waste of DPS (pet is not attacking during running time), but if it works for you.

You can put in targets for almost any command.
/petattack [@MainCharName-target]

If the pet is in defensive, it will attack the mob that the hunter is attacking, automagically. They changed that like in 3.1 or so. So you can just have the hunter....
/assist [@MainCharName]
and the pet will go after the same mob.

Hope that helps and good luck.

Currently I just use
/assist focus
on my hunters, maybe I should try adding the petattack as well then. Cause now when I tell my hunter slaves to assist and shoot at a specific target, one or two of the pets often face another mob after they have charged. And they do this even when original target still is alive, it happened several times when I attacked elite mobs in dungeons.

[Solon]

I have never liked assist for just that reason, it's slow. Your /petattack can occur before the assist registers. Change to

/petattack [@pettarget] [@target] [@focustarget]

Pick a conditional or use more than one. Vyndree had a nice one that allowed you to send your pets against different mobs, and as each mob died that pet would go help another pet. Some searching http://www.dual-boxing.com/showthrea...et+assignments