Part of this was posted in another thread and figured it should be in the right forum so easier for folks searching etc.


Ualaa mentioned how to set this up.

V
ery simple.

Create a new mapped key.
Probably in the General Keymap, so it applies to all your teams.

Give it a hotkey of choice.
Two steps.
Steps advance on press and release.
Step 1, sends IWT keybind to all clients.
Step 2, sends 's' or 'downarrow' to all clients.
I tried this but couldn't quite get it to work, but then I may be horribly confused on IWT.

Here is my response

Struggling getting this working.

Set it up with the following


1) Hold any Keystroke Actions while Hotkey is Held: Off.
2) Execute a step when the hotkey is : Pressed or Released
(you mentioned advance on press and release which I assume is same thing)

3)Use FTL modifiers: off (though tried on as well)

Then added 2 steps.

Step 1)
target: All w/o current
Key Map: General
Mapped Key: Interact with Target

Step 2)
Target: All W/o current
Key combination: S

Doesn't seem to work, I think my first step might be bad... If I change the first setting to hold any keystroke actions to off, I get 1/2 the behavior. First push nothing, second time move back.

I haven't done anything with IWT specifically yet, so perhaps I'm not understanding that.
I'm sure I'm missing something silly , thanks for any help