new to keyclone help pls

[kraemder]

I'm trying to use this to 3 box World of Warcraft atm. I have it setup so the left half of the screen is one instance of of wow, and the other two are on the right side.

My problem is that the account that gets loaded into the left side always, always, loads up at 800x600 which is very bad because for some reason the wow ui is messed up so that I can only see a portion of the hotkeys at the bottom - the ratio is way off.

Updating this to 960x600 fixes the problem fine. Only, it bumps me out of maximize mode and I can't get back into it. I'm in normal wow window mode. If I save and start over then I'm back at square one, in 800x600 mode.

The frustrating thing is that the other two windows boot up into 960x600 just fine. They work fine. If I skip keyclone and just boot wow up on its own, then it goes directly into 960x600. Keyclone is passing some information onto the program when it boots, forcing it to boot up incorrectly and I can't figure a way to change this.

Any help is appreciated.

[keyclone]

hi kraemder and welcome to the forums!

keyclone is attempting to 'maximize' your wows. you must have enabled it in the setup/maximizer panel. you can disable it if you want... but it should all work for you.

first off, if you squeeze the wow windows so they all fit on the screen, you will most likely chop something off. using the add-on 'bongos' will help move the bars around so you will have full access to all the buttons

also, use the command editor to setup which wow clone goes into which region. (regions are part of the maximizer layout)

if you need more info, please feel free to drop me a note.

good luck and have fun,

Rob (aka keyclone)

[Diamndzngunz]

How many copies of wow you have installed? If so make sure the graphics setting are set to what you want.

Also use UI scale to scale down the action bars and stuff.