Quote Originally Posted by Xzin
If you make them all flat, they will match up perfectly.

If you try to angle them, there is no physical way with flat monitors to make the edges all match up.

So in short, don't tilt them down any and they should match up (assuming the same make and type of monitor of course).
I was looking at some of the documentation...my printout that came from the box seem to be different. From the website, it shows that it can be tilted up and down, but from the instruction paper sheets I got, I was instructed to install it so that it can be tilted left and right (to have the semi closed book look).

I've positioned them flat but the top two just wouldn't fit ... I even use that even tool (with water inside to see if it's aligned) and the tool says they are, but the edges arent on the monitor to monitor comparison

So which one is it really? :| The bolt on the left and right (to allow it to tilt up and down) or the bolt on top and bottom (to allow it to tilt right and left ).