I have seen a few other topics on this issue but none with an answer and none with my exact situation.

I have two computers (PCA and PCB)

I have purchased one license for PCA and I am able to use Keyclone on it ok. However I load keyclone on PCB and try and connect to it from PCA. on PCB I am getting the "Badly Formatted" message and sometimes if I reboot both computers then launch Keyclone then I can get them to connect and clone keys but only for a short time, after about 5 min it will disconnect and they will not reconnect.

I had this setup working perfectly before I swapped out my second PC (PCB) but since that is not the PC that my license is tied to it should work correct?

any suggestions on whats going on?

Thanks!