Not sure of the problem...(Newbie mistake...probably...)

Hey guys, i'm very new to the forum. (1st Post :D ) And equally as new to dual-boxing. I started up two new accounts today, and made two gnomish warlocks, since I already have a 70 Shaman.

I followed the PDF guide you have here somewhere, and successfully had both accounts running, using the Maximize thing within Keyclone.

Here come's my problem- I created the macros using the guide, as well as sorting out the key bindings using BONGO, they all work fine, except for both characters attacking.

Only the Main ever attacks, the other never does anything other than get into combat stance, and refuses to target, nor bolt anything. I'm not sure what i'm doing wrong since i have little ideas about Macros.

Can anyone help me? Also, if anyone has any tips to organise the two better, it would be much appriciated.

RogueTide

Just to test it, make this macro on your add:

/target whateverthenameofyourmainis

/assist

When you use that macro, it will target your main and get its target at the same time, doesn't matter if it's a mob, player or even a dead target. Then press wich ever buttons you set for your add to cast something and /enjoy!

If that doesn't work check you Keyclone settings ?