Printable View
im using a castsequence macro, is there like anyway to reset so it will begin with the first spell when i loose combat or such?:)
currently looks like this
/castsequence Crusader Strike, Judgement of Wisdom, Divine Storm,
Crusader Strike, Consecration, Exorcism, Crusader Strike, Judgement,
Crusader Strike, Divine Storm, Consecration, Crusader Strike, Judgement
any1 can improve or fix my problem i would rly preciate:)
and also is there anyway to reset the macro when the last one is done in the sequence? in long battles:)
the macro i have dosnt rly work that well, so was thinking if any could see the problem:/ ive read how to get the best dps so this is the way:
0 Crusader Strike
1.5 Judgement
3 Divine Storm
4.5 Crusader Strike
6 Consecration
7.5 Exorcism
9 Crusader Strike
10.5 Judgement
12 Free Time
13 Crusader Strike
14.5 Divine Storm
16 Consecration
17.5 Crusader Strike
19 Judgement
20.5 Free Time
21.5 Crusader Strike
23 Exorcism
24.5 Divine Storm
26 Crusader Strike
27.5 Judgement
29 Consecration
30.5 Crusader Strike
32 Divine Plea
34.5 Repeat from start
any1 who can nail that to a macro that resets when combat ending?:)
/castsequence reset=combat Crusader Strike, etc, etc
And it always resets at the end...haven't you tried it to see this?
i have but while in battle she stops attacking, and when i swith to her her macro is all grey, so there must be something wrong, but i cant see it:/ but ur combat thingy works good:)Quote:
Originally Posted by yaki
ah found the problem, now just wondering one more thing, can i reset the macro if she change target aswell?
Divine Plea has a cooldown. If it is on cooldown, it will stay stuck until it comes off cooldown and can cast. Remove DP from the macro and trigger it manually. And really, you should probably look at using a /click setup for Ret. Your castsequences has too many spells with cooldowns that are going to cause hangups.
Edit - And yes, use reset=target, but that's probably only going to make matters worse. http://www.dual-boxing.com/showthrea...792#post239792
If it goes grey on a paladin tank macro, my first bet is that your seal is down and it's stuck on Judge. Anything on a cooldown will also block your macro. With paladins, I use a 6 macro and a 9 macro...it gets stuck less than a monolithic approach, and in a pinch I can let it reset down to something castable.
The syntax is reset=A/B/C/etc. You could do reset=target/combat. I try to avoid target reset, there can be situational complications. I also usually incorporate a decay timer, which looks like reset=5/combat/etc where the number is the number of seconds since the last time the macro was invoked NOT since the beginning of the sequence!
aiight:) ill try look for a click setup:) thx!
You can use...
reset=combat (This resets when combat ends).
reset=target (This resets when you change targets).
reset=# (This resets when you haven't pressed the macro for that many seconds).
reset=alt (This resets when you press the macro while alt (or Control or Shift, if you change the mod used) is held).
Your macro is still subject to a maximum of 255 characters.
Unless you're using some macro addon for longer macro's.