Keyclone -- Need to Tab over for commands to go

I never had this problem before when I was using keyclone on 2 computers . When I try to run both Wow windows off my same pc with 1 copy of keyclone it only sends some commands.

For example I have 6 set up as follow and 7 as assist. Hitting 6 will tell it to follow, and 7 will tell it to assist, but pressing 1 will only make the primary char fire. If I quickly use alt tab to go to the slave, and then back and hit 1 they both fire as they should for the duration. For the next target though I have to alt tab again or the slave just sits there.

Any ieas?

Vista? If so run as administrator

It is and I am.

Are you using a white list or black list at all?
The default should broadcast anything else to all windows.

I'm not sure what you mean? I never modified any settings. I will look at it and try to figure out which is which.