Issue with Keyclone v1.9i

I updated to v1.9i when you discontinued support for the 1.8 versions.

I'm using a 5-box set up, with 4 windows along the top and one window in the bottom left.
This leave a fairly moderate amount of space in the bottom right open for another application (browswer, chat window etc).

The Bottom Right region is region 0.
The Left is region 1.

Almost every time I open Keyclone, region 1 does not have a region assigned to it, in the Set Up >>> Command Editor >>> Region (drop down box).

I can work around this by assigning a region from the box, and then clicking Apply, then Ok. And then in the box, just run wow1 and click Connect. However this is annoying that I now have to manually do this almost every time I start Keyclone.

Ok, you are going to have to clarify your layout because you are saying the bottom right is region 0 but its also open for another application?

When you upgraded did you copy over your settings or did you set them up again? I would recommend the later and not just putting 1.9i on top of what you already had.

And here is the obligatory 'run it as admin' statement, maybe the upgrade removed that setting from things :)

Basically my set up looks like this:


111222333444
111222333444
5555555
5555555
5555555

The Keyclone which goes into the 1's on this chart, is acting up.
It didn't act up this latest start, but did the two before.
Basically, the wizard did not put one of the accounts into a region.
And after that point, manually putting it there, it remembers maybe half the time.

Vista Home Premium, Service Pack 1, 64-Bit.
Run as admin, etc.