Keyclone dual-monitor

Apologies; I feel like this question must have been asked before, but 20 minutes of searching the forums found nothing.

I have two monitors; one at 1920x1200 and one at 1280x1024. Horizontal span doesn't work well with different resolutions, so I'm not using it. I would like my main monitor to contain the main instance of WoW, with 4 other windows (not actually WoW instances, just VNC viewers) tiled at 640x480 each on the other monitor.

I'm using keyclone. I've seen some posts describing this setup, but they seemed to use Maximizer instead. Is it possible to do this using just Keyclone's maximizer feature? Right now, keyclone only lets me input coordinates that are on my primary display.

correct. currently keyclone does not support dual monitor setups, unless you run in horizontal spanning mode.

the next version, which should be out within the week, will have support for multi-monitors.

before I got my 2x24 I had the same setup as you, so I set the right hand display which was the 19inch to be my primary display and started 4 sessions with keyclone maximiser which tiled them on the primary, then I just opened up the main wow without keyclone and ran it on the 24...worked ok for me.