warlock cast sequence macro?

iv been using a cast sequence macro

Code:

---

#showtooltip
/cast [modifier:alt] Amplify Curse
/stopcasting [modifier:alt]
/castsequence reset=combat/target Corruption,Curse of Agony

---

but when i edit it for my alt it only casts curruption

Code:

---

#showtooltip
/target focus
/assist
/cast [modifier:alt] Amplify Curse
/stopcasting [modifier:alt]
/castsequence reset=combat/target Corruption,Curse of Agony

---

what is going wrong?

take the reset target clause out.

I had this problem. It's because you target your main then target the mob the main is interested in.

So in essence you are resetting the target twice, meaning the macro will get reset.

(22:07:38) (Griznah|Leopold) evildave: dude, ofc it only casts corr
(22:07:59) (Griznah|Leopold) you have it resetting the sequencing for when it changes target, and you change target in the macro

i think you could use:

#showtooltip
/assist focus
/cast [modifier:alt] Amplify Curse
/stopcasting [modifier:alt]
/castsequence reset=combat/target Corruption,Curse of Agony

cause assisting shouldn't change your target, if the target of the main hasent changed (not 100% sure)

/assist focus
/cast Amplify Curse
/cast Trinket1
/cast Trinket2
/castsequence reset=target Curse of Agony, Corruption, ....

This should fire anything that is ready to be fired again. you can fire a trinket as well as anything in the castsequence at the same time, I think the same goes for amplify curse. This may be a noisy setup but it will always keep everything up. I'm worried that a long cast sequence can't be made silent unless you are using Trinity or something that allows for longer than 255 characters in a macro. I currently have my shaman silent trinkets

As mentioned, just condense lines 2 and 3 into one line:

/assist focus

If you do that and your focus/main has the same target, it won't see it as a target change and won't reset the macro. ;)

why dont yeh use a different key for target/assist ?