Slave not listening

[Lisharts]

I'm currently dual boxing two characters (Pally - Master, Mage - Slave) and all has been going fantastically until about an hour ago.

I'm on a mac and using Clonekeys. I noticed suddenly that my mage was no longer assisting. So I shut everything down and then reopened but still no change.

That's when I noticed that pressing 2 on my pally wasn't pressing 2 on my mage, it was toggling to action bar 2. For the life of me I can't figure out what I've done to achieve this but does anyone have any idea how to get it back to how things were. It's annoying because I'd been finding things so easy up until this.

Any help would be greatly appreciated.

[drarkan]

I haven't used clonekeys at all, so I have no specific advice on how to look into the program, except that you should check your broadcast/keystroke settings, perhaps start a new config and test it with that. From there, compare the two config files and see what might have changed. Also check that no drivers were deleted from say an antivirus program, some boxing programs might be considered malware cause of how they handle communication between programs, never experienced that myself, but I've heard stories.

If that doesn't work, wait for someone who's used clonekeys to respond, or check the clonekeys site (don't know the site address) and failing that, check into products that are offered through this site as they are well maintained and supported, though you may need to emulate windows to run it, I don't know if they run on a mac.

[shadewalker]

Sounds like there may be a modifier key stuck down in the software. Is shift 2 the default for page to action bar 2? Does pressing a different number key page to a different action bar?

Did you try restarting the computer or just shutting down the wows and clonekeys?