Any way to synchronize /stopcasting with /castsequence?

[Hachoo]

Ok so with my priest+locks I have an issue.

I have a lot of "interrupt what I'm doing to cast something" but on a staggered list.

Ie: death coil. Each warlock has a macro something like:

/stopcasting
/castsequence reset=120 Death Coil,,,

And so on.

I have a similar macro for fear, howl of terror, etc.

The problem is, all 4 warlocks stop casting when I use it (obviously) but I can't seem to find a way to synchronize the stopcasting with the castsequence so it only stops casting on the warlock who has Death Coil ready. Is there any way to do this?

If I remove the stopcasting and just spam the button so that as soon as the current cast is done it casts death coil I have 2 problems. 1) Almost 100% of the time more than 1 warlock casts the spell. 2) in a real emergency I dont have 1-2s to wait to cast the spell.

Any way to make this a bit more friendly and usable?

[Harem]

Hmm...

Maybe use the keyclone's round robin feature? So it only goes to the lock who should be casting - you then have to break it down to:
/stopcasting
/cast Death Coil

Not sure as I haven't done this yet.

[Hachoo]

Wow I didn't even think about that. I AM using keyclone after all - sounds like one huge advantage to using the keyclone roundrobin instead of the built in macros. I think I will try that on wed/thurs (my LCD died last night and I have to wait for a new one to arrive before i can multibox again) :(

[Oatboat]

round robin on keyclone is very easy to setup. a little buggy sometimes but it gets the job done. I use it with my bloodlust on shamans.

[thinus]

Hmm...

Maybe use the keyclone's round robin feature? So it only goes to the lock who should be casting - you then have to break it down to:
/stopcasting
/cast Death Coil

Not sure as I haven't done this yet.

I have my Earth Shocks setup like this for spell interuptions and it works great, just a shame about the range.